HOLDEN HQ HJ V8 308 253 ENGINE wiper WIRING LOOM HARNESS LOOMS (manifold to starter)

Description

 HOLDEN HQ HJ  V8 253 308 engine / wiper  wiring harness.

This wire harness will be rewired with new wires & terminals. Looms will fit 308 253 8cl or to replace old hard cracked STD engine looms.The one shipped will be a basic 253 308  loom  with tacho & heater  to fit  internal reg ALT wiper wires are built in with this loom . loom run across manifold and down the front of the motor then to starter

Can be used in a performance application with  4mm wire  to coil to suit electronic ignition or std points dizzy . this loom run across the fire wall to passenger rail then to starter does not have emission / aircon  or idle solenoid wires. It has a 6mm main red (std one is 5mm) with a fusible link we use heat shrink & we solder the terminals. it will not have a main plug fitted unless you send a change over,

fitting instructions with main plug layout come with our looms

if you need the gts charge wire  (to suit gts dash)  there listed in our store. 

LOOM WILL BE SENT WITH NO MAIN PLUG (YOU REUSE YOURS) IF YOUR SUPPLY ONE it will be fitted 

As this model loom was made so many ways as STD you will have to make sure this will fit you car and read all the listing.

1, loom run across the fire wall to passenger rail then to starter

2,loom run across manifold and down the front of the motor then to starter

 read listing to how the loom is made both ways are as gmh made the loom for different models as same to internal or external alternators.